Publicité
4. Putting the blood-pressure monitor into operation
4.1. Inserting the batteries
a) Insert the batteries (4 x size AA A1.5V), thereby observing the indicated po-
larity.
b) If the battery warning
20% power to warn user the batteries will be run out .
c) If the battery warning
ty and must be replaced by new ones
Attention!
After the battery warning
the batteries have been replaced.
Please use «AAA» Long-Life or Alkaline 1.5V Batteries.The use of 1.2V
Accumulators is not recommended.
If the blood-pressure monitor is left unused for long periods, please
remove the batteries from the device.
4.2. Reading the set date
Please press the TIME button and the date will be shown in the display.
4.3. User selection and setting the time / date
User selection: This advanced blood pressure monitor allows you to track
blood pressure readings for 2 individuals independently
a) Before measurement, make sure you set the unit for the intended user. The
unit can track results for 2 individuals. (User 1, User 2)
b) Press the TIME button for at least 3 seconds. The display now indicates the
set user, during which the set user blink. To confirm, press ON/OFF button .
c) Click the MEMORY button to select User
d) We suggest the first person to take their pressure to be User 1.
Setting the time, date
This blood-pressure monitor incorporates an integrated clock with date dis-
play. This has the advantage, that at each measurement procedure, not only
the blood-pressure values are stored, but also the exact moment of the mea-
surement. After new batteries have been inserted, the clock begins to run
TIME 12:00 and DATE 1-01.You must then re-enter the date and current time.
For this, please proceed as follows.
icon appears in the display, the batteries remain
icon appears in the display, the batteries are emp-
icon appears, the device is blocked until
24
Publicité
