Publicité
8. Recommendations for a proper access to the model
Preliminary assembly
8.1
EP - EP-ED series: connect the heater R0 and motors through entry knockout L4; to avoid possible damage to wires use
the rubber fairlead supplied separately with unit.
8.2
EP/B - EP/B-ED series: the heater R0 and the motors are prewired in junction box SD; use entry knockout L4 and rubber
fairlead supplied with unit for all electric connections.
Access/Repositioning
8.3
Use screws A to remove or reposition fan shroud L2 and drain pan L1.
8.4
To remove the heater R0, remove the heater clips MF and pull the heater out from below.
L1
=
Drain pan
L2
=
Fan shroud
L3
=
Casing
L4
=
Entry knockout
MF
=
Heater clip
R0
=
Heater
SD
=
Junction box (fans and heaters) standard on B models
Figure 3
25
www.modine.com
Publicité
