Télécharger Imprimer la page

Hansgrohe AXOR Uno 16182181 Instructions De Montage / Mode D'emploi / Garantie page 2

Publicité

SAFET Y NOTES
WARNING:
To avoid the risk of product
failure, property damage, and personal injury,
do the following:
This product should be installed by a licensed
professional plumber.
This product is for use with drinking water only.
A code-approved electrical box (not included)
with 110 V electrical service must be installed for
the transformer in a safe, dry, accessible loca-
tion. It must be installed by a licensed electrician
in compliance with all applicable local codes.
The electrical supply must be equipped with an
approved circuit breaker.
Failure to follow these instructions may result in
product failure and property damage, and may
void the warranty.
INSTALL ATION CONSIDERATIONS
⁄ Please read over these instructions thoroughly be-
fore beginning installation.
have all tools and supplies needed to complete the
installation.
⁄ This product is intended only for public spaces.
⁄ The rough must be installed so that the outside surface
of the finished wall falls between the "min" and "max"
lines on the plaster shields.
⁄ To insure correct operation of the faucet, the hot sup-
ply must be installed on the left, and the cold supply
must be installed on the right.
⁄ Only one outlet on the iBox is used. The second out-
let must be sealed with a ¾" plug.
⁄ The rough and the transformer must all remain acces-
sible for future servicing
⁄ The supply hose for the spout (included with trim kit
#38010XX1) is for use with a ⅜" stop (not included).
Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary
to request warranty parts.
2
E N G L I S H
Make sure that you
ELECTRICAL SERVICE
Trim kit #38010XX1 includes a transformer to
provide power for the faucet
⁄ This unit includes approximately 23 feet of flexible
plastic conduit for the wire connecting the transformer
to the iBox.
The conduit provided may not be code approved
in all municipalities. If it is not, the homeowner
or the installer must provide approved conduit.
Hansgrohe is not responsible for the cost of the
conduit.
⁄ The provided conduit must be secured at least every
20". The bend radius must be greater than 4".
TECHNICAL INFORMATION
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water
heater.
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*

Publicité

loading