Publicité
• Do not use abrasive products, abrasive
cleaning pads or solvents.
10.4 Cleaning the filters
The filter system is made of 3 parts.
C
B
A
1. Turn the filter (B) counterclockwise and
remove it.
2. Remove the filter (C) out of filter (B).
3. Remove the flat filter (A).
4. Wash the filters.
5. Make sure that there are no residues of
food or soil in or around the edge of the
sump.
6. Put back in place the flat filter (A). Make
sure that it is correctly positioned under
the 2 guides.
2
7. Reassemble the filters (B) and (C).
8. Put back the filter (B) in the flat filter (A).
Turn it clockwise until it locks.
CAUTION!
An incorrect position of the filters can
cause bad washing results and damage
to the appliance.
10.5 Cleaning the lower spray arm
1. To remove the lower spray arm, pull it
upwards.
2. Wash the spray arm under running water.
Use a thin pointed tool, e.g. a toothpick,
to remove particles of soil from the holes.
Run water through the holes to wash soil
particles away from the inside.
3. To install the spray arm back, press it
downwards.
ENGLISH
17
Publicité
