Publicité
4. Install Hitch and Bumper beam – continued
Install the bumper beam on top of hitch, loosely install (8) hex flange nuts onto studs in vehicle.
5. Tighten all factory M10 hex nuts with torque wrench to 38 Lb.-Ft. (52 N*M), then all 7/16-14 fasteners to 50 Lb.-ft. (68 N*M)
6. Trim fascia –Locate the center of the fascia. Using a tape measure, marker, and utility knife, cut a notch in the bottom of fascia approximately 3-1/2'' wide by 4-3/4"
tall.
See Figure 4. NOTE: Be sure area is clear of all electrical wiring before trimming.
7.
Reinstall the Bumper Fascia, taillight covers, and underbody panel in reverse order of Step 1 using all existing fasteners. Be sure to reconnect all wiring harnesses.
©2024 Horizon Global Corporation - Printed in México
L C
4-3/4"
3-1/2"
Bottom View of Bumper Fascia
Proper torque is needed to keep the
hitch secure to the vehicle when towing.
For additional security, thread locker can
be used on all fasteners.
Sheet 8 of 24
76655NP
8-14-24
Rev. A
Publicité
