Publicité
1. Remove Bumper Fascia continued:
(f) Using a 7mm socket, remove (16) screws from underbody panel. Remove panel and set aside.
(g) Apply painter's tape around rear Bumper Fascia seams to protect the paint.
(h) Partially remove the Wheel Well Trim, starting at the bottom rear edge of trim piece, use a plastic trim tool to gently pry up and out on bottom rear edge of trim
high enough to expose (2) screws holding the fascia. Then, using a T15 torx bit remove (2) screws holding fascia, both sides. Disconnect side marker light wiring from
wheel well trim.
(i) Bumper Fascia, starting from the wheel well area working toward the center, remove bumper fascia using plastic trim tools and gently pulling the fascia until clips
are released. Disconnect all wire harnesses from fascia and set fascia aside.
(f)
(h)
©2024 Horizon Global Corporation- Printed in México
(h)
(f)
(i)
Sheet 6 of 24
76655NP
(i)
8-14-24
Rev. A
Publicité
