Publicité
(a)
(f)
1. Remove Bumper Fascia - Open the tailgate.
(a) Using a plastic trim tool, gently pry and remove (1) plastic cover next to each taillight.
(b) Using a 7mm socket, remove (1) screw next to taillight that holds the fascia, (1 each side).
(c) Using a T15 torx bit, remove (1) screw near bottom of tailgate opening, (1 each side).
(d) Using a T15 torx bit, remove (3) screws from inside area holding rear wheel well liner (3 each side).
(e) Using a T15 torx bit, remove (1) screw from bottom area near wheel well (1 each side).
(f) Using a 7mm socket, remove (16) screws from underbody panel. Remove panel and set aside.
(g) Apply painter's tape around rear Bumper Fascia seams to protect the paint.
(h) Partially remove the Wheel Well Trim, starting at the bottom rear edge of trim piece, use a plastic trim tool to gently pry up and out on bottom rear edge of trim high
enough to expose (2) screws holding the fascia. Then, using a T15 torx bit remove (2) screws holding fascia, both sides. Disconnect side marker light wiring from wheel well
trim.
(i) Bumper Fascia, starting from the wheel well area working toward the center, remove bumper fascia using plastic trim tools and gently pulling the fascia until clips are
released. Disconnect all wire harnesses from fascia and set fascia aside.
©2024 Horizon Global Corporation. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76655, 84655, CQT76655
(b)
(d)
(e)
Sheet 3 of 24
Fastener Kit: 76655F
Carriage bolt
①
Qty. (2)
7/16-14 x 1.50" GR5
②
Qty. (2)
Spacer Block 1/8 x 7/8 x 2
3
Qty. (2)
Conical washer 7/16"
4
Qty. (2)
Hex nut 7/16-14
5
Qty. (2)
Pull wire 7/16"
Always wear SAFETY GLASSES
when installing hitch
(f)
76655NP
8-14-24
Rev. A
Publicité
