Publicité
1. We suggest that you should cut off the power for 10Mints after keep running 2HS, so that it's good for maintain the
treadmill.
2．The belt would slip if too loose during using；if the belt is too tight,it would affect the performance of motor and
increase the abrasion of roller and belt.The belt can be lift away from the deck for around 50 — 75mm if the degree
of tightness is just well.
Maintenance and Malfunction Treatment
1) The surface of the treadmill should be kept clean, pull out the power line
before cleaning. You can clean the running belt and the surface of the
treadmill with a soft and wet cloth.
2) The running belt is adjusted at factory; it may runs defectively after
transportation and use. Turn off the treadmill before adjusting, pull the belt in
the center, and then adjust the left and right bolts in rear roller with hex
spanner (See figure ) it is better to adjust 1/2 circle once. Then turn on the
switch, check if the belt
10 runs defectively when the running speed is 4~5 km/h.
12.Meanings of error message codes
Error code
Communication
abnormality:
abnormal
E1
communication
between the controller
and
meter after powering
on
Controller
detect the voltage
of motor
No
signal: while there is
E2
voltage output from
the controller to the
DC
feedback can not be
received
motor for more than
3s.
Incline motor
correction failure
E4
or error
Failure description
Stop the controller to enter failure state. It can not be started up. The
electronic meter displays the error code and the buzzer sounds for 3
times.
Possible reasons: The communication between the controller and the
electronic meter is blocked; check each section of connection of the
communication wires from the electronic meter to the controller and
the
electronic
ensure that all core wires are well connected. Check whether wirings
between the electronic meter and the controller are damaged; if yes,
replace the damaged wire.
1.check if the motor wire is well connected to the controller.
2.Stop and enter the failure state. The electronic meter buzzer sounds
cann't
for 9 times and the error code is displayed. No display at other areas. If
the system enters into standby state after about 10s of failure state,
restart can be conducted.
speed
sensor
Possible reasons: If speed sensor signal is not received for more than
3s, check whether the sensor connector is well plugged or whether it is
damaged; plug it well or replace the sensor.
3.Stop and enter the failure state. The electronic meter buzzer sounds
motor,
speed
for 9 times and the error code is displayed. No display at other areas. If
recovering to the normal state and enter into the standby state after
from
the
stop, normal startup can be implemented.
Possible reasons: Check whether motor wires are well connected; re-
connect motor wires. Check whether the controller emits abnormal
odor; replace it if yes.
re-check
connection;Change inverter and re-check it;Change the incline
motor and re-check;
Solutions
incline
motor
after
power
on;Check
the
Publicité
