Urmet 1083 Notice page 44

C4.013 Fit a 9V (MN1604/6LR61) battery in the
ringer.
The ringer is equipped with two jumpers
indicated by W1 and W2.
Remove one of the two jumpers for two-
tone or one-tone operation as shown in
the following table:
JUMPERS
SOUND TYPE
W1
THREE-TONE
X
TWO-TONE X
ONE-TONE
VD.007 Floor call button.
VV.004 Attention: Don't remove the jumper
between pins "Z" of the last riser
interface.
VV.007 If door open warning service is needed,
the following connection has to be carried
out on the call station (for preset devices
only).
VV.008 Setting the dip-switch "1" in position
OFF.
VX.006 See the instruction booklet provided with
the product for fi tting the accessory in the
device.
44
All manuals and user guides at all-guides.com
NOTES ON DIAGRAMS
W2
Both jumpers
X
inserted
Jumper W1 only;
remove W2
Jumper W2 only;
remove W1
Lock release
NC CONTACT =
CLOSED DOOR
VX.008 Connect the devices to a fi lter and power
(Rev. A)
line protection device.
Sch./Ref.1382/85
A
E L
L
N
C
N
G
D
A) Protection
B) Filter
C) (Neutral)
VX.014 Dusk switch or similar device for switching
lights on, where appropriate.
VX.021 Cut or remove the jumpers Z on the
device(s).
VX.037 On device setting the jumper/dip-switch
"Z" in position "ON".
V2.003 Switch the line termination "Z" to the off
position (see instruction booklet provided
with the product).
§
The diagrams are at the end of this booklet.
Sch./Ref.1332/86
B
1 1
2 2
IN OUT
L N
F
D) Earth G) Mains ~
E) (Step) H) Line ~
F) Utility
DS1083-029E
H