Urmet 1083 Notice page 41

– Hook up the handset of apartment station A. It will beep to indicate exit from programming mode.
§
The other functions will not be lost if the buttons are programmed for this function because the
intercom call is made with the handset off-hook.
1b) With handset on-hook.
– Hold the • button pressed for longer than 5 seconds. The yellow LED will blink slowly to confi rm that
programming mode is selected. In all cases, the device will quit programming mode and save any
changes after 10 minutes.
– Press the button to be programmed for at least 3 seconds, until the confi rmation tone sounds.
– Go to the user who will be called by pressing the button (user B) and press the door opener button. The
apartment stations will be beep to indicate that they have been programmed.
– Alternatively, go to a calling station and press the calling button of user B. The apartment station being
programming (A) will beep to indicate that it has been programmed. The apartment stations of user B will
ring at the same time. Ignore this call.
– Hold the • button pressed for longer than 5 seconds to quit programming mode.
– Check the programmed function: pick up handset A and press the programmed button. Check that all the
apartment stations of user B ring and check for audio after replying.
– You will need to program apartment station B to call A to make the opposite call possible.
INTERCOM FUNCTION IN THE SAME APARTMENT
Go to the apartment station to be programmed as caller (apartment station C1).
There are two different ways to enter programming state (check which method is used on the instruction
booklet supplied with the product):
1a) With handset off-hook.
– Hold the door opener button (1) pressed and pick up the handset (2). The apartment station C1 will output
a tone to indicate that programming is in progress.
– Press the button to be programmed. The apartment station C1 will output a confi rmation tone.
– Go to the apartment station that the button will call (apartment station C2) and press the door opener
button. The apartment stations C1 and C2 will be beep to indicate that they have been programmed.
DS1083-029E
All manuals and user guides at all-guides.com
C1
1
C1
3
2
41