Urmet 1083 Notice page 37
Masquer les pouces
Voir aussi pour 1083:
- Manuel d'utilisation (49 pages) ,
- Manuel d'installation (48 pages) ,
- Manuel de l'utilisateur et d'installation (20 pages)
Publicité
Instead, if the door unit is confi gured as main unit and several columns are present in the system, an
association must be created between the buttons and the users of the different column proceed as
follows:
•
Access advanced confi guration (see the instruction manual of each product).
•
Set the ID dip-switch to the code of the fi rst column in the system (column 0 typically).
•
Press the button corresponding to user 0 of the selected column. All the subsequent buttons will be
automatically associated to the users of the column itself in sequence.
•
Repeat the operation on all the columns.
•
Reset the ID dip-switch in start position.
•
Set again the switches to positions used to confi gure door lock release time and guaranteed communication
time in order to exit from the advanced confi guration.
Example:
•
System with 3 columns, the fi rst with 4 users, the second with 6 users and the third with 8 users.
•
Access advanced confi guration.
•
Set the ID dip-switch to 0.
•
Press the upper button of the door unit (fi rst button).
•
Set the ID dip-switch to 1.
•
Press third button of the fi rst button module (fi fth button) to associate user 0 of column 1 in this manner.
•
Set the ID dip-switch to 2.
•
Press fi rst button of the third button module (eleventh button) to associate user 0 of column 2 in this
manner.
•
Reset the ID dip-switch in start position.
•
Quit advanced confi guration mode.
The fi nal confi guration will be:
§
The confi guration of column 0 is not required if the default settings of the door unit are maintained
because all buttons are assigned to this column.
Repeat the operation on all the main door units.
If the door units are confi gured as secondary, but each one must call a different group of users, the following
steps can be performed:
•
Access advanced confi guration (see the instruction manual of each product).
•
Set the ID dip-switch of the call module with the apartment station code that will be associated to the
fi rst button (offset);
§
The offset code can only be included between 0 and 31
•
Change the position of AUX dip-switch no. 5 (the call module emits a confi rmation tone);
•
Set again the AUX dip-switch no. 5 in its previous position (the call module emits a confi rmation tone);
•
Set again the ID dip-switches in their previous position;
DS1083-029E
All manuals and user guides at all-guides.com
4 USERS
C
1
OUTPUT
Column 0 start Column 1 start
6 USERS
2
3
4
5
6
7
8
9
10
11
Expansion module
Column 2 start
8 USERS
12
13
14
15
16
IN
37
Publicité
