Urmet 1083 Notice page 11

The electric lock of the door unit can be operated when a video door unit or door unit call is received without
needing to establish a conversation.
If there are several apartment stations in parallel, the extensions will ring in sequence. The user's extension
0 will also switch the video door phone if the call comes from a video door phone station. In this case, during
the call pick-up time (60s from the call), the video door phones of the other extensions can be switched on
by pressing the auto-on button
picks up.
If the picture is already displayed, pressing button
calling station only in cycle.
The picture of the main camera will appear only on the apartment station that picked up after picking the
call up.
The camera picture will therefore be normally shown on only one apartment station at a time.
AUTOMATIC SWITCH-ON FUNCTION
Press the button on the video door phone to switch the auto-on function on if the apartment station
is in stand-by. When the auto-on function is selected, the camera of the main station with ID equal to 0
is displayed. Pressing the button
applicable) connected to the main station 0, and then the other main stations and fi nally the secondary
stations present in the column, including additional cameras. The cycle will resume from the main station 0
at the end of the cycle.
Pick up the handset or press the button for establishing a conversation on hands-free video door phones to
establish an audio communication with the selected door unit. The door can be opened at any time when
the audio conversation is in progress.
Auto-on will end automatically after 60 seconds if the audio channel is not activated.
CALLS TO SWITCHBOARD
The apartment stations are provided with a dedicated switchboard call button. Pick up the handset or press
the audio button on hands-free apartment stations after pressing the switchboard call button to make the
call.
INTERCOM CALL FORWARDING
After having programmed an apartment station button for intercom function (see programming paragraph),
pick up the handset or press the audio button on a hands-free apartment station to activate audio and then
press the intercom calling button. The following cases can occur according to the column state:
• Free column: the calling apartment station will output a confi rmation tone (1 beeps) and the called
apartment station will ring. Communication is established when the called user picks up.
• Busy column: the apartment station outputs a warning tone (4 beeps in rapid sequence). Hang up and
try again later.
FLOOR CALL FUNCTION
The apartment stations are equipped with a pair or terminals (CP) for connecting the fl oor call button. The
apartment station will ring with the set tone for 3s when the button is pressed. The tone will be different
from that of the other calls. Connect this button to only one extension if there are extensions in parallel. The
apartment stations will ring in sequence.
SUPPLEMENTARY RINGER
The apartment stations are provided with a pair of terminals (S+, S-) for connecting a supplementary ringer
or relay or wireless call repeater. This ringer is controlled when any call tone is generated.
DOOR OPEN FUNCTION
The apartment stations can monitor the physical state of the doors if a sensor is connected to the SP and
CT terminals on the calling stations. The red LED will light up when the door of a main calling station is left
open and will blink if the door of a secondary station is on. The function is only active for the last called door
phone or video door phone on which the door opening button was pressed and corresponding to the last
calling door unit.
DS1083-029E
All manuals and user guides at all-guides.com
(video switching function) until one of the called user's video door phones
again will display the stream from all the additional cameras (where
will show the stream of the surveillance cameras of the
11