Ibiza sound XTK8A-MKII Manuel D'utilisation page 4

Masquer les pouces

page de 52

/ 52
Signets

• To avoid injury or falls, do not use the product as a seat.

•

To avoid hearing loss, do not expose yourself to high volume levels for long periods of time.

• The device complies with current European legislation regarding human exposure to electromagnetic fields.

DISCONNECT DEVICE: The power outlet must be installed near the equipment and be easily accessible.

STAND MOUNTING

• If you use a stand, be sure to observe the following precautions:

• Check the stand specification to be certain it is designed to support the weight of the speaker.

• Observe all safety precautions specified by the stand manufacturer.

• Always verify that the stand is placed on a flat, level, and stable surface.

• Route cables so that performers, crew, and audience will not trip over them and pull the speaker over.

• Remove the speaker from the stand before moving the stand or adjusting its height.

• Before moving the box, remove all connected cables.

• Do not use the speaker's handles for suspended installation. Doing so can result in damage and injury.

• Be sure to fully extend the legs of tripod type stands.

• Position the stand so that the legs do not present a trip hazard.

• Do not attempt to place more than one speaker on a stand.

FUSE REPLACEMENT

• Disconnect the power cord before replacing a fuse. Always replace with the same type of fuse.

CONNECTIONS

• Before connecting the box to other units, turn off the power of all devices. Before turning the power on or off

for all devices, set all volume levels to minimum.

• Use only speaker cables to connect the speakers to the speaker jacks.

• Be sure to observe the amplifiers rated load impedance, particularly when connecting speakers in parallel.

Connecting an impedance load outside the amplifier's rated range can damage the amplifier.

OPERATION

1. Prior to switching the unit on, turn down the volume control to the minimum.

2. Connect the audio source to the appropriate input jack.

3. Another speaker can be connected to the output jack so that two boxes can be daisy chained.

4. Connect the box to the power supply.

5. Switch on the audio source, followed by the active speaker.

6. Set the volume with the applicable control.

7. Adjust the bass & treble.

REAR PANEL

XTK8A-MKII / XTK10A-MKII

SD card input

USB input

Display

MODE button: press to select the desired input

source

Short press to skip backwards, long press to re-

duce the volume of the MP3 player

Short press to play/pause the music, long press to

select a folder

Short press to repeat the song, long press to link

two speakers via TWS

Short press to skip forwards, long press to in-

crease the volume of the MP3 player

MANUAL - XTK-A-MKII series

XTK12A-MKII / XTK15A-MKII