Guide Bar And Saw Chain Combinations - Husqvarna 435 II Manuel D'utilisation

Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna chain saw models 435 II, 435e II, 440 II and 440e
II. These chain saw models equipped with either of the listed guide bar and saw chain combination(s), fulfills the
requirements according to ANSI B175.1-2000 (Gasoline Powered Chain Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw models Husqvarna 435 II, 435e II, 440 II and 440e II met the kickback performance requirements of ANSI
B175.1-2000 when tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is
also classified as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI
B175.1-2000. We recommend to use only the listed combinations of bars and chains for chain saw models Husqvarna
435 II, 435e II, 440 II and 440e II. Other chain saw models may not meet the kickback requirements when equipped with
the listed guide bar and saw chain combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna chainsaw models 435 II, 435e II, 440 II and 440e
II. The listed combination(s) of powerhead, bar and saw chain meet all requirements outlined in Canadian Standards
Assosiation Z62.1-03 (Chain Saws) and Z62.3-04 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H30 is evaluated and listed as a Type C Low Kickback Saw Chain according to
the provisions in Z62.3-04.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Guide bar and saw chain combinations

Length, inch Pitch, inch
13
15
0.325
16
18
Saw chain filing and file gauges
32 – English
TECHNICAL DATA
Guide bar
Thickness of drive
links, inch
0.050
Max. nose radius Type
10T Husqvarna H30
Saw chain
Drive link count
56
64
66
72
1155355-49 Rev.1 2013-09-20