Publicité
• When storing the device, allow to
cool before folding.
• Inspect the device frequently for
signs of wear or damage. if signs of
wear or damage are found, or if the
device has been used inappropriately
or is not working, return to the suppli-
er before switching on again.
The cable and external battery of the
device may cause entanglement, chok-
ing, tripping or crushing hazards if not
properly arranged. The user must en-
sure that any protruding electrical con-
nections and cables are arranged in a
safe manner.
Presentation
Thank you for choosing the graphene Foot
Warmer by lAnAFORM Cozy and comfort-
able, this foot warmer will delight even the
chilliest of people! Equipped with a 3-inten-
sity graphene heating system, this foot warm-
er provides soothing warmth in just a few min-
utes, enveloping you in unparalleled comfort.
The graphene Foot Warmer features cord-
less operation thanks to an external battery,
so you can use the foot warmer in any situa-
tion, whether in your armchair, office chair or
any other room in your home.
Description
01 On/OFF button and heat
intensity setting
02 On/OFF & temperature indicator light
03 Removable cover
04 integrated pocket for external battery
05 UsB connector
06 Battery status indicator button
07 Charge status display lED
08 UsB-C port
09 UsB-A port
10 UsB-A port
11 UsB cable
Preparation
before use
External battery
The rechargeable external battery must be
fully charged before first use. To do this, use
the UsB cable supplied with an adapter fitted
with a 5V/2A UsB output socket ( not included ).
The external battery is fully charged when the
four battery lEDs ( 7 ) remain on continuously.
Charging time : approximately 3 hours.
Heating cushion
Place the foot warmer on a hard, flat surface.
Make sure the cover is correctly placed in the
foot warmer by securing it with the Velcro.
Connect the UsB cable to the foot warmer
connector ( 5 ) and the UsB port ( 9 ) of the ex-
ternal battery; the lED lights up successively
blue/green/red before turning off.
The foot warmer can also be used directly by
connecting the UsB connector to a 5V/2A UsB
socket ( not included ).
Instructions
Press the On/OFF button ( 1 ) for several sec-
onds to switch on the device. The heat starts
at the lowest level and the lED lights up green.
1
By successively pressing the On/OFF button
( 2 ), you can switch between heat levels 1, 2
or 3 ( medium level 2 = blue lED; highest lev-
el 3 = red lED ).
The device switches off automatically after ap-
proximately 30 minutes or can be stopped at
any time by briefly pressing the On/OFF button
( 1 ). if you wish to continue using the product
after this time, press the On/OFF button again
store the external battery in the integrated
pocket ( 4 ).
Publicité
