Publicité
Smart Stop Adjustment
A Smart Stop Ring is included at every Quick Attach joint. Position the Smart Stop Ring to limit the arm's range of motion. The
marked angle will be in the center of the range of motion.
NOTE: The stop rings must be configured in such a way that does not allow the monitor to pass behind the rear edge of the
unit.
①
Attach Arm To Base Stem
Before adding each link, adjust the Smart Stop according to
Step 3. In a triple link configuration, one must be a 4" link.
1
Insert the first link into the mount until the release button
(A) locks in place.
2
Insert the next link into the first link.
3
To remove a link, press the release button and lift upward
near the joint.
NOTE: The installation order of the links must not allow the
monitor to pass behind the rear edge of the unit.
②
③
④
Arm can rotate
without stopping
Arm can rotate 180˚
Arm can rotate 90˚
⑤
A
5
Publicité
