Publicité
5.12 Sent Photo Size
(This menu item can only be selected if mobile is switched on).
If you use the camera in an area where there is only 2G network coverage and sending images takes
significantly too long, you can change the method of sending to "M" or even "S", which will speed up
sending images.
S = 1024 x 768 pixels
M = 1280 x 960 pixels
L = 1920 x 1440 pixels
Note: This setting only applies to the images sent via mobile, not the images stored on the SD card.
5.13 Sent shots/h
(This menu item can only be selected if mobile is switched on.)
You can set the maximum number of photos/videos sent per hour via mobile in preset levels between
1 and ∞.
Outdoors, for example, moving branches can be heated by the sun's rays and, in combination with wind,
lead to undesirable images.
Note: If an event happens after the tenth image with a limitation of, for example, 10 images/hour, it will be
recorded and saved on the SD card, but no longer sent. Only events that happen after the next 60 minutes
are then sent again. This can result in a surveillance gap of up to one hour.
5.14 GPS data
Note: This menu item can only be selected if mobile is switched on.
Here you can set whether the ZEISS Secacam should determine its GPS position. This allows you to display the
location of your camera in the ZEISS Secacam app.
To save power, the camera updates its position data once when it is switched on. This may take some time
depending on the position, meaning that the position is not visible on the first images.
5.15 Battery type
The ZEISS Secacam can also be used with LR6 (AA) 1.5 V Mignon rechargeable batteries. For the battery
display to work correctly (rechargeable batteries tend to have a higher current capacity at lower voltage
values), you can select here whether you are using batteries or rechargeable batteries.
Note: When using rechargeable batteries, the battery display may differ from the actual charge status.
5.16 Date/time
When the "Automatic" setting is selected, the camera loads the date and time from the mobile network.
If necessary, you can adjust the time to the corresponding season or time zone using + and -. When the
"Manual" setting is selected, you can set the date and time yourself. Use the up and down arrow buttons to
change the respective setting, and the right and left arrow buttons to move forward or back one position.
Confirm the settings with "OK" to complete. The date and time are now included in every recording.
5.17 Language
Choose the desired menu language. You can choose between German, English, Spanish, French and Italian.
5.18 Footer cam name
You have the option to choose a name that will appear at the bottom of your images. If you select the "On"
option, you can enter a name with a total of 12 characters using the arrow buttons. Use the up and down
arrow buttons to change the respective character and the right and left arrow buttons to move forward or
back one position.
35
Publicité
