Publicité
Selecting the spin speed
Press the «Spin»
ton to change the spin speed, if
you want your washing to be
spun at a different speed to the
one selected by the appliance.
You can also select «No spin»
«Rinse hold»
silence plus»*.
The maximum speeds are :
for Cotton, Synthetics, Wool,
Handwash, Jeans, Sport : 800 rpm (ZWQ380),
600 rpm (ZWQ360),
for Delicates : 700 rpm (ZWQ380), 600 rpm
(ZWQ360).
At the end of the programme, if you have selec-
ted «Rinse hold»
or «Night silence plus», you
then need to select a «Spin»
programme to finish the cycle.
«Rinse hold»
The washing machine will not drain the water
from the last rinse, so will not crease the laundry.
Selecting options
You must select the dif-
ferent
selecting
gramme
pressing
Pause»
(see Programme table).
Press the desired but-
ton(s) ; the corresponding lights come on. If
pressed again, the lights go out. If one of the
options is not compatible with the selected pro-
gramme, the «Start/Pause»
flashes red.
*depending on model
30
«Prewash» option
The appliance runs a prewash at 30°C max. The
prewash finishes with a short spin cycle for cot-
pushbut-
ton or synthetic programmes, and with an empty
cycle for delicates programmes.
«Quick» option
*
,
The washing time will be reduced according to
* or «Night
the programme selected.
«Rinse plus» option
The washing machine will add one or more rin-
ses during the cycle.
This option is recommended for people with sen-
sitive skin and in soft water areas.
Temporary :
Press the «Rinse plus»
option is only active for the selected programme.
or «Drain»
Permanent :
Hold down the «Option»
pushbuttons for a few seconds. The option is
permanently activated, even if the appliance is
switched off.
To deactivate it, repeat the process.
«Delay start»
options
after
the
pro-
and
before
the
«Start/
This option allows you to delay the start of a
pushbutton
wash programme by 3, 6 or 9 hours by pressing
the «Delay start» pushbutton.
You can change or cancel the delayed start time
at any time before you press the «Start/Pause»
pushbutton, by pressing the «Delay start» pus-
hbutton again (when all indicators are off, the
pushbutton
wash programme will start immediately).
If you have already pressed the «Start/Pause»
pushbutton and you want to change or cancel
the delayed start, proceed as follows :
• To cancel the delayed start and start the cycle
pushbutton. The
and «Rinse plus»
Publicité
