Publicité
Before each trip, check that the strap divider is cor-
rectly adjusted and fastened!
Adjusting the strap divider (Fig. C)
•
Open the strap divider.
•
The strap divider must be positioned in such a way that the straps are tight but comfortable.
The strap divider must be placed under the ears, the straps should not cover the ears.
•
Close the strap divider.
Removing/attaching the ear padding (Fig. F))
1.
First, pull the chinstrap out of the loops on the ear padding.
2.
Carefully pull the ear padding straight out of the snap lock grooves.
3.
Attach the ear padding by carefully pressing the tab at the base of the ear padding into
the groove on the side of the helmet. The soft side of the ear padding should face inward.
4.
Thread the chinstrap back through the loops on the ear padding.
Operating the one-handed size adjustment system (Fig. E)
The integrated size adjustment system can be adjusted freely with a turning knob on the back
of the head:
• Smaller = turn clockwise
The correct helmet position (Fig. H)
•
The helmet must always sit horizontally on your head.
•
If the helmet is too far forward, this can impair your vision.
•
If the helmet is too far back, your forehead is not sufficiently protected.
Attaching the ski goggles (Fig. I)
In addition to the visor, ski googles can also be attached to the helmet. To do so, the visor
must be in the highest position. Alternatively, the visor can be removed completely. To do
this, the nuts on both sides of the visor need to be opened using a blunt tool.
1.
To attach the ski goggles, open the flap at the back of the helmet.
2.
Put the ski goggles in place and pull the band around the helmet.
3.
Then, do up the flap to fasten the band to the helmet.
PO-2025-10 D H Ski- und Snowboardhelm SP-52V IAN458652_2401_CB8.indd 21
PO-2025-10 D H Ski- und Snowboardhelm SP-52V IAN458652_2401_CB8.indd 21
Ski & Snowboard Helmet with Photochromic Visor
• Larger = turn anticlockwise
21
GB
IE
22.05.2024 17:03:02
22.05.2024 17:03:02
Publicité
