Télécharger Imprimer la page

Napoleon GDI-30GN Instructions D'installation Et D'utilisation page 16

Publicité

16
7.2
ANTI CONDENSATION SWITCH
This appliance has the option to go from an
electronic intermittent pilot ignition (IPI) to
a standing pilot for cold climates. The anti
condensation control switch (standing pilot) is
located on the left of the control panel. Using
your fi nger, fl ip the switch up for standing pilot,
or down for intermittent pilot ignition.
8.0 WIRING DIAGRAM
This appliance comes equipped with a battery back-up. Connect the battery holder to the wire harness before
using the appliance. Place near the IPI board. (Batteries not included).
NOTE: If battery backup is used, it must be connected to a 6 volt battery pack.
f i r e - p a r t s . c o m
DC BACK-UP
-
+
TRANSFORMER
+
-
DC SUPPLY
W415-0832 / C / 06.07.12
ACS/IPI
SWITCH
ON / OFF
SWITCH
IPI / CPI
ON / OFF
DISCONNECT THESE
CONNECTORS TO THE
ON/OFF SWITCH AND
CONNECT TO
OPTIONAL WALL /
THERMOSTAT SWITCH.
ANTI CONDENSATION
CONTROL SWITCH
VALVE
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
IPI BOARD
DFC

Publicité

loading

Ce manuel est également adapté pour:

Gdi-30gp