Publicité
5.3
MEDIA TRAY INSTALLATION
Secure the media tray to the burner using 6
screws (W570-0001).
When removing the media tray make sure the
glass media are away from the center of the
screen, exposing the burner, remove screws
and lift media tray out.
When replacing burner, absolutely no glass media
can be in cup surrounding the orifi ce. HINT: If
glass falls into cup and surrounds the orifi ce,
insert a clean bag into a vacuum cleaner and
vacuum out glass media. Replacement glass
media can be ordered from Wolf Steel Ltd.
f i r e - p a r t s . c o m
5.4
MEDIA INSTALLATION
CLEAN THE GLASS MEDIA PRIOR TO INSTALLATION. BEFORE APPLYING THE CLEANED GLASS, ENSURE
DO NOT CHANGE OR SUBSTITUTE THE GLASS MEDIA MATERIAL PROVIDED WITH THIS APPLIANCE. IF
REPLACING, USE ONLY THE REPLACEMENT GLASS MEDIA AVAILABLE FROM YOUR AUTHORIZED
GLASS MEDIA OVER THE BURNER MUST NOT BE MORE THAN ONE LAYER HIGH. MORE THAN ONE LAYER
Evenly spread the glass media onto the media tray, covering the burner tube and following the natural shape of
the media tray.
In some installations, glass media over the burner tube may cause a "Puffi ng" sound. If this sound is
excessive, simply push the media away from the burner ports.
NOTE: The distribution of glass media over the burner tube will infl uence the fl ame height. When the
fl ames impinge on the glass, the glass may discolour slightly and the edges may soften.
CLEANING GLASS MEDIA
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
5.5
LOGO PLACEMENT
Remove the backing of the logo supplied and place on the glass viewing door,
as indicated.
OVER THE BURNER WILL CAUSE FLAME LIFTING AND SOOTING PROBLEMS.
WARNING
!
THAT IT IS DRY.
DEALER / DISTRIBUTOR.
13
74.1A
½"
LOGO
½"
97.1
W415-0832 / C / 06.07.12
Publicité
