Publicité
Leveling The Monitors (Dual-Monitor Application Only)
1
If the crossbar is not level, it can be tilted around the central pivot (A).
2
If the monitors are at different heights after leveling the crossbar they can be individually adjusted with
the screw located on top of the monitor tilt (B). To raise a monitor, turn the screw clockwise. To lower,
turn counter clockwise.
3
If the adjustment bottoms out before reaching alignment, move the second monitor in the opposite
direction.
①
A
Weight Adjustment
Your monitor should move up and down easily and stay in
place once adjusted. If it is difficult to adjust or moves without
assistance, it is not properly balanced.
M8.1 Arm - Total Weight Range: 6-28 lbs. (2.7-12.7 kg)
Single Monitor - Max weight: 28 lbs. (12.7 kg)
Dual Crossbar - Max weight per monitor: 12.5lbs (5.6 kg)
1
Press the Upper Arm Link (A) downward until Adjustment
Screw (B) is visible.
2
If the arm rises up on it's own, the lift force is too high
and can be decreased by rotating the Adjustment Screw
counter clockwise (towards -) with a 5 mm hex key. If the
arm falls down with the weight of the monitor, the lift force
is too low and can be increased by turning the Adjustment
Screw clockwise (towards +).
3
The current counterbalance setting can be seen through
the counterbalance indicator (C) on top of the upper arm.
This information can be used to quickly set multiple arms
to the same level without needing the monitors to be
installed.
CAUTION: Do not over tighten the screws as it can damage
the screw head or threads.
②
③
A
④
C
B
B
7
Publicité
