Adjusting Top Thread Tension; Changing Presser Foot - Singer Futura CE-100 Manuel D'instruction

ADJUSTING TOP THREAD TENSION

STRAIGHT STITCHING
The good looking appearance of your stitching is largely
determined by the balanced tension of both top and bobbin
threads. The tension is well balanced when these two threads
'lock' in the middle of layers of fabric you are sewing.
If, when you start to sew, you find that the stitching is irregular,
you will need to adjust the tension control.
Make any adjustments with presser foot 'down'.
BOBBIN TENSION
The bobbin tension has been correctly set at the factory, so you
do not need to adjust it.

CHANGING PRESSER FOOT

Be sure needle is in the up position. Raise presser foot lifter.
1. Push presser foot release button to remove the foot.
2. Place the desired foot on the needle plate aligning the presser
foot pin with the foot holder.
3. Lower the presser foot lifter so that the foot holder snaps on
the foot.
32
Under side
Côté de dessous
Reverso
Well balanced
Correct
Bien equilibrada
Top side
Côté de dessus
Cara
Top stitch too tight
Fil supérieur trop tendu
Puntada superior
demasiado apretada
Decrease tension
Diminuer la tension
Disminuir tensión
3
Presser foot lifter
Levier de verrouillage
du pied
1
Palanca pie prensatelas
Foot release button
Levier de verrouillage du pied
Palanca de desprendimiento
prensatelas
Top stitch too loose
Fil supérieur trop lâche
Puntada superior
demasiado floja
Increase tension
Augmenter la tension
Aumentar tensión
2
Foot holder
Support du pied
Sujetador prensatelas