Publicité
Before removing the cloth from the brush,
wait a few minutes to allow the cloth to
cool. Then rest a foot on the symbol relative
to the tab of the cloth and pull the steam
mop upwards.
WARNING: Do not use the brush without
the cloth.
6. CLEANING CARPETS AND
RUGS
WARNING: Before steam treating surfaces
(wood or laminate floors, carpets, rugs,
leather
and
fabrics
especially
those
treated), consult the surface manufacturer's
or the supplier/installer's instructions and
always perform a test on a section that
is out of view or on a sample. Allow the
steamed surface to dry to ensure that there
is no deterioration, change of colour or
deformation and that the surface stands up
to the temperature of the steam.
Ensure that the instructions in Chapters 1 and
2 have been followed.
6.1
Insert the brush with the cloth attached
into the special frame so that it can slide on
the surface (13).
6.2 Unlock the appliance brush by tilting it
backward and using your foot.
6.3 Select the program type (7). For this type
of surface, we recommend the medium level
(MED). The appliance will start dispensing
steam (the tank will light up to indicate that
the appliance is dispensing steam). It is then
possible to start cleaning by moving the mop
back and forth. To stop dispensing steam,
press the central Steam Set button several
times on the control panel (7) until the light
turns on
or hold it down for more than
2 seconds.
During cleaning, it is possible to insert the
power cable into the upper hook to avoid it
getting in the way (11).
6.4 To remove the frame, just rest a foot on
the relative symbol
mop upwards.
7.
CLEANING GLASS AND
WINDOWS
WARNING: To clean glass surfaces during
cold weather, preheat the windows starting
to steam from a distance of about 50 cm
from the surface.
and
any
surfaces
that
are
delicate
and pull the steam
Use only the Portable Steam Cleaner.
Make sure that chapter 1 has been completed.
Turn
on
the
instructions listed in Point 2.4 and connect the
accessories as shown in Section 3.
7.1
Adjust the intensity of the steam (7).
For this type of surface, we recommend the
lowest level (MIN).
7.2
To dispense steam, press and release
the steam trigger located under the handle of
the portable unit (14) (the tank will light up
to indicate that the appliance is dispensing
steam).
7.3
To clean windows and mirrors, connect
the window cleaning accessory to the Portable
or
Cleaner or to the flexible hose for hard-to-
reach areas, steam the surface thoroughly to
dissolve the dirt and then wipe the surface
again without steam to remove the dirt. The
brush has a sponge, ideal for removing dirt
and absorbing excess moisture.
7.4
To stop dispensing steam, press and
release the steam trigger located under the
handle of the portable unit (14).
8.
CLEANING TILED WALLS,
INTERIOR DOORS AND CABINET
DOORS
Use only the Portable Steam Cleaner.
Make sure that chapter 1 has been completed.
Turn
on
the
instructions listed in Point 2.4 and connect the
accessories as shown in Section 3.
8.1
Adjust the intensity of the steam (7)
for this type of surface we recommend the
medium level (MED).
8.2 To dispense steam, press and release
the steam trigger located under the handle of
the portable unit (14) (the tank will light up
to indicate that the appliance is dispensing
steam).
8.3 Connect the flexible steam hose to the
portable cleaner and attach the triangular
brush with the cloth on it (only for Polti
Vaporetto SV660/650_STYLE models) and
go over the surface, releasing the steam by
pressing the steam trigger of the Portable
cleaner, to remove the dirt. For the Polti
Vaporetto
SV620/610_STYLE
is possible to attach the window cleaning
accessory with sockette (15A) to the portable
hose and go over the surface.
8.4 To stop dispensing steam, press and
release the steam trigger located under the
handle of the portable unit (14).
| 18 |
appliance
following
appliance
following
models,
the
the
it
Publicité
