Fulgor Milano F7IRC36O1 Mode D'emploi page 22

6. INTERNAL LAYOUT
EN
6.1 Internal Layout (positioning,
adjustment, removal).
Drawer
Fixed to the slide guides with two thumbscrews.
> to remove the drawer, unscrew the thumbscrews,
lift slightly at the front and pull forward. Be sure to
support the rear of the drawer when removing.
Shelves
The shelves are positioned on the left and right by
two pins engaged in the shelf supports.
To reposition a shelf it is recommended to removed
contents for safety and ease of movement.
> Lift the shelf slightly and pull towards you to
disengage the pins from the support geometry in the
guides.
> Slide the shelf to the new position and engage the
support pins in the corresponding regions of the
shelf support guides. Prior to loading the shelf with
goods in the new position, test the positioning for se-
cure support by applying moderate pressure down
on the top surface with a hand while keeping the
other hand in a supporting position in case the shelf
is not properly seated.
22
Door Bins adjustment
To adjust the position of the door bins, push up
slightly and pull the bottom forward giving it a
slightly tipped back positioning and slide up or
down the rail to the desired position. Push in the
bottom and allow it to seat into the designated slots
on the guide rails.
2
1