Publicité
ENGLISH
1. APPEARANCE DIAGRAM
1_Power Button: When the power is on, long press this key to select Power Off/Restart; Short press it to turn
off/turn on the screen.
2_PTT/customize key: Open the specified application/switch quickly with the "customize key" setting in the
system. See 10.3 for more details.
3_Volume Button: Adjust the volume.
4_USB Interface: Type-C interface for mobile phone charging and data transmission.
5_Main MIC
6_SOS key: Alarm using one key, which will be used after setting in the multi-function alarm application. See 10.2
for more details.
7_LED Indicators: Instructions for mobile phone status. See 9.4 for more details.
8_Front Camera
9_Knob: For switching software intercom groups. See 10.1 for more details.
10_Speaker
11_Return Button/Home Button/"Recently Opened Applications" Button: Return to the previous menu/
return to home screen/display the pending programs set in the background.
12_Professional audio interface: Can connect 13-pin headset/RSM and is compatible with MOTO RSM
(PMMN4022A).
13_Camera Button: In other applications, long press to enable camera function. In camera application: Short
press to use the camera function, and long press for continuous shooting.
14_Flashlight: 4-flashing highlighted.
15_Secondary MIC
16_Rear Camera
17_Battery Cover Screw: Rotate anticlockwise to loosen and clockwise to tighten the battery cover.
18_Pogo pin for charging: Connect the desktop charger.
2. INTRODUCTION
This document contains information and safety regulations which are to be observed without fail for safe
operation of the device RG750 under the described conditions. Non-observance of this information and
instructions can have serious consequences and / or may violate regulations.
Please read the manual and these safety instructions before using the device. In case of any doubt, the English
version shall apply.
3. RESERVATION
The content of this document is presented as it currently exists. Power Idea Technology (Shenzhen) Co.,
Ltd. Does not provide any explicit or tacit guarantee for the accuracy or completeness of the content of this
document, including, but not restricted to, the tacit guarantee of market suitability or fitness for a specific
purpose unless applicable laws or court decisions make liability mandatory.
Power Idea Technology (Shenzhen) Co., Ltd. reserves the right to make changes to this document or to
withdraw it any time without prior notice. Changes, errors and misprints may not be used as a basis for any
claim for damages. All rights reserved.
Power Idea Technology (Shenzhen) Co., Ltd. cannot be held responsible for any data or other loss and direct
or indirect damages caused by any improper use of this device.
4. EU-DECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end of this manual.
5. FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must be withdrawn from
use immediately.
Measures must be taken to prevent any accidental restarting of the device. The safety of the device may be
compromised, if, for example:
• Malfunctions occur.
• The housing of the device shows damage.
• The device has been exposed to excessive loads.
• The device has been stored improperly
• Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back to Power Idea
Technology (Shenzhen) Co., Ltd. to be checked.
6. FURTHER SAFETY ADVICE
• Do not touch the screen of the device with sharp objects. Dust particles and nails may scratch the screen.
Please maintain the screen clean. Remove dust on the screen with a soft cloth gently, and do not scratch the
screen.
• Do not put the device in environments with excessive temperatures, as this could lead to heating of the battery,
resulting in fire or explosion.
• Do not charge the device near any flammable or explosive substances.
• Charge the device under dry indoor conditions only.
• Do not charge the device in environments with much dust or humidity.
• Do not use the device in areas where regulations or legislatives prohibit the use.
• Do not expose the device or charger to strong magnetic fields, such as are emitted from induction ovens or
microwaves.
4
Publicité
