Water Spray; Dry Ironing - Beper 50.131 Manuel D'instructions

Steam iron Use instructions

WATER SPRAY

Check that the filler cap (2) is full of water, direct the spray (1) forward the clothes. Press several
times the water switch (5).
When used for the first time, it is recommended to press several times on spray button (5) before
you obtain the desired spray.
Attention: do not use water spray function on silk.

DRY IRONING

Set the steam indicator (3) on in order to not to use steam function. Set the soleplate temperature
by using the thermostat (8).
The light indicator (7) illuminates and switch off when the soleplate is at good temperature.
Start ironing after iron reached desired temperature.
Please note that the soleplate reached lower temperatures when used without steam.
FILL AND EMPTY THE TANK
This has to be made only when the appliance is unplugged.
Always dry the iron or hands before unplug the appliance after filling the tank.
Make sure the temperature indicator (8) is on "min" and steam indicator (3) is on .Raise the filler
cap (2) and slowly fill using a funnel
Do not exceed the maximum limit of the tank.
Do not introduce water into the iron, because of electric shock risks. Close the filler cap (2) when is
full and plug the appliance to the socket.
It is possible to use tap water as well as demineralised water if tap water is to hard.
After ironing, unplug the appliance from the socket and empty the tank.
To empty the tank turn over the iron above the sink (or other).
Otherwise place the iron in vertical position and plug it to the socket.
Select the temperature indicator (8) on "MAX" and steam indicator (3) on steam symbol
and let the steam come out from the iron by pressing burst button (4).
CLEANING
Unplug the appliance from the socket.
To remove dirt on the soleplate, use a wet cloth or with a little quantity of non abrasive detergent
when the soleplate is still hot.
For hard dirt, use special detergent.
Always dry the soleplate after cleaning.
Clean the whole iron with a wet cloth without detergent.
Do not use metallic sponge or abrasive detergent.
16