Publicité
EN
In this situation
is
displayed and does not
proceed.
Fixed display.
5.3. Error Code Table
When any of the following errors are displayed, try turning the display off and on again.
Display
is displayed
is displayed
is displayed
is displayed
6. Specifications
Specifications are subject to change without notice.
Input sensitivity
Input signal range
Load cell excitation voltage
Load cell drive capacity
Temperature coefficient Zero
Temperature coefficient Span
linearity
Maximum display resolution
Display
Display update
Operating Conditions
Installation environment
Altitude
Power Supply
Overvoltage category *
Pollution degree *
Dimensions
Weight (approximately)
Dust and water protection
* Applicable to FG-D-ACWP (AC power model) only
･The weighed value is unstable due to drift, vibration or other factors.
A breeze or vibration may be affecting measurement.
Check around the weighing pan.
･Check the connection of the load cell cable.
･No zero display when the display is turned on.
Remove anything that is on the pan.
･Refer to the [FG-D-CWP / FG-D-ACWP Instruction Manual] on the A&D
website (https://www.aandd.jp) and perform zero point sensitivity
adjustment.
･Did you use the "hold function" ?
･Refer to the [FG-CWP / FG-ACWP Series Instruction Manual] on the A&D
website (https://www.aandd.jp) and change the function
･Turn off scale and turn it on again.
The temperature sensor has failed.
The memory (circuit) has failed.
The internal circuitry has failed.
The mass sensor has failed.
0.1 μV/d min. (d: minimum division)
-16 mV to 16 mV
5 V ± 10 %
Up to 4 x 350 ohm loadcells
±0.02 μV/°C typ. ±0.1 μV/°C max.
±3 ppm/°C typ. ±15 ppm/°C max.
±0.01 % of full scale
100,000
7 segment LCD with backlight (Character height 30 mm)
Approx. 10 times/second
-10 °C to 40 °C, 85 % R.H. or less (non-condensing)
Indoor use only
Altitude up to 2,000 m
<FG-D-CWP (USB power model)>
Power supplied from AC adapter, mobile battery, or USB Type-A port
USB Cable Length: Approx. 3 m
(USB cable is also used for communication.)
<FG-D-ACWP (AC power model)>
AC mains (100 V to 240 V, 50/60 Hz, 0.1 A Max)
AC Cable Length: Approx. 3 m
II
2
Width 240 mm × Depth 76 mm × Height 155 mm
1.6 kg (Includes stand)
Complies with IP67
8
Confirm these items
Content
.
Publicité
