Publicité
The manufacturer is not responsible for radio
interference caused by unauthorized modi-
fications to this equipment. Such modifica-
tions could void the user's authority to oper-
ate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interfer-
ence, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class
B digital devices, pursuant to Part 15 of the
FCC rules. These limits are designed to pro-
vide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio com-
munications. However, there is no guarantee
that interference will not occur in a particu-
lar installation. If this equipment does cause
harmful interference to radio or television re-
ception, which can be determined by turning
the equipment off and on, the user is encour-
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
a drill.
1605A002J3 GDR18V-1950C 202404.indd 7
page heading
FCC Caution
Industry Canada
Intended Use
This tool is intended for the driving, tightening, and loosening of bolts,
nuts and various threaded fasteners. This tool is not intended for use as
SAVE THESE INSTRUCTIONS
aged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the re-
ceiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
"Exposure to Radio Frequency (RF) Signals:
The wireless device is a radio transmitter and
receiver. It is designed and manufactured not
to exceed the emission limit for exposure to
radio frequency (RF) energy set by the Minis-
try of Health (Canada), Safety Code 6. These
limits are part of comprehensive guidelines
and established permitted levels of RF en-
ergy for the general population.
These guidelines are based on the safety
standards previously set by international
standard bodies. These standards include a
substantial safety margin designed to assure
the safety of all persons, regardless of age
and health.
This device and its antenna must not be co-
located or operating in conjunction with any
other antenna or transmitter.
(1) this device may not cause interference,
and
(2) this device must accept any interference,
including interference that may cause un-
desired operation of the device.
7
4/15/24 8:48 AM
Publicité
