Publicité
To reduce the risk of injury read the operating instructions included with
Bosch GCY42 connectivity module. Operating instructions for GCY42 con-
nectivity module include important information not covered in this manual.
Bluetooth®
Do not use the power
tool with Bluetooth® in
the vicinity of gas stations, chemical plants,
areas where there is danger of explosion
and areas subject to blasting. Do not use
the power tool with Bluetooth® in airplanes.
Do not use the power tool with Bluetooth®
in the vicinity of medical devices. Avoid op-
eration in the direct vicinity of the human
body over longer periods of time. When us-
ing the power tool with Bluetooth®, interfer-
ence with other devices and systems, air-
planes and medical devices (e.g., cardiac
pacemakers, hearing aids) may occur. The
Bluetooth® word mark and logos are regis-
tered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Robert
Bosch Tool Corporation is under license.
Follow
and warnings provided
by your Bluetooth® device manufacturer.
Failure to follow recommended procedures
could result in personal injury or property
damage.
Exercise extreme caution
when using Bluetooth®
devices to control or change power tool
functions. Operation of the device may be in
a different area than the paired power tool.
Paired devices may have functionality which
allows timed event programming, including
automatically powering on (e.g. flood light).
Depending upon the power tool, these unat-
tended operations or function changes with-
out direct line of sight to the paired tool
could result in personal injury or property
damage.
Always check tool settings
before use. Settings may
be different than when the tool was last
used. The connectivity module enables trans-
fer of data and settings based on Bluetooth®
wireless technology. With module installed,
select tool settings may be changed remotely
by a paired Bluetooth® device and user in-
stalled app.
16
1605A002J3 GDR18V-1950C 202404.indd 16
page heading
Connectivity
radio interface. Local operating restrictions,
e.g. in military sites or hospitals, are to be
observed. Transmitters have demonstrated
an ability to unintentionally interfere with
other devices.
Think Safety
SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE TOOL IS BEING USED.
Using "Bosch Toolbox" App
After pairing your tool with a mobile device
you can adjust certain functions or check the
status of the power tool using Bosch Toolbox
app (Fig. 8 and Fig. 8).
Every time you change any setting, the tool
all
instructions
will confirm the changes by flashing the Sta-
tus indicator LED 12 blue.
A. Help button – Tapping this button will
B. Tool photo – Tapping the photo will let
C. Power tool battery charge status – The
D. Power tool nickname – Tapping the "pen-
E. Connection status bar – The connection
F. Assigned modes – Allows you to define
G. RPM Adjustment – Allows you to select
The connectivity module
GCY42 is equipped with a
bring up help screen.
you customize the photograph of the tool.
number of battery icons in green indi-
cates the estimated charge level of the
battery pack. Note: Number of battery
icons may not be equal to the number of
LEDs on the battery fuel gauge.
cil" icon will let you customize the tool
nickname. You can also do it when chang-
ing the tool photo.
(signal) strength is indicated by vertical
bars. You can use the toggle switch to dis-
connect the tool from your mobile device.
two modes of operation (A and B), speci-
fying options such as Auto Shut Off, Auto
Slow Down, and the direction of rotation
for each mode.
the rotation speed.
4/15/24 8:48 AM
Publicité
