Electrical System; Part Lists - Huvema HU 360 VAC X 1000 Mode D'emploi

It is recommended to clean the slide ways, lead screw and feed shaft every shaft with a soft brush. Lubricate
lightly.
Warning
Using the wrong oil will damage the machine.

10. Electrical system

Figures 27 and 28 – Electrical diagram
Warning
Connecting the machine to the mains and repairs of the electrical system may only be
performed by a qualified electrician!
Always use the electrical diagram to connect the machine to the mains. Always use a connection that can be
secured and sealed.

11. Part lists

Figures 29, 30 and 31 – Headstock
Figures 32 and 33 – Gear box
Figures 34 and 35 – Apron
Figure 36 – Cross slide and longitudinal slide
Figure 37 – Compound rest
Figure 38 – Tailstock
Figure 39 – Bed and shafts
Figure 40 – Housing and covers
Figure 41 – Change gears
Figure 42 – Thread cutting dial
Our products are frequently updated and improved. Minor changes may not yet be incorporated in this manual. Always state the year of
build, type and serial number of the machine in correspondence.
Manufacturer and importer assume no responsibility for defects which result from not reading the manual carefully or wrong use of the
machine. No rights can be derived from this manual.
All rights reserved. No part of this booklet may be reproduced in any form, by print, photoprint, microfilm or any other means without
written permission from the publisher.
© 2004, Huberts bv, Kennedylaan 14, Veghel, the Netherlands.
-46-
Internet: www.huvema.nl