Publicité
BTL KKJJ00- _ _ _ _ -C05A _ _ _ 0-000S32
Magnetostrictive Linear Position Sensor – Rod Style
5
Installation and connection (continued)
Installation recommendation for hydraulic cylinders
If installing horizontally in a hydraulic cylinder (measuring
lengths > 500 mm), we recommend affixing a slide element
to protect the rod end from wear.
Dimensioning of the detailed solutions is the
responsibility of the cylinder manufacturer.
The slide element material must be suitable for the
appropriate load case, medium used, and application
temperatures. E.g. Torlon, Teflon or bronze are all possible
materials.
Slide element
Fig. 5-4:
Example 1, BTL installed with slide element
The slide element can be screwed on or bonded.
► Secure the screws so they cannot be loosened or lost.
► Select a suitable adhesive.
Piston rod
Rod
Slide element
Fig. 5-5:
Detailed view and top view of slide element
There must be a gap between the slide element and piston
bore that is sufficiently large for the hydraulic oil to flow
through.
Options for fixing the position magnet:
–
Screws
–
Threaded ring
–
Press fitting
–
Notches (center punching)
www.balluff.com
Position magnet
Slide surface
Flow gap
If installed in a hydraulic cylinder, the position
magnet should not make contact with the rod.
The hole in the spacer ring must ensure optimum guidance
of the rod by the slide element.
Position magnet
Fixing of position magnet
Spacer ring
Fig. 5-6:
Fixing of position magnet
An example of how to install the BTL with a supporting rod
is shown in Fig. 5-7.
Position magnet
(e.g. BTL-P-1028-15R)
Supporting rod made of non-magnetizable material
Fig. 5-7:
Example 2, BTL installed with supporting rod
english
11
Publicité
