Publicité
BTL KKJJ00- _ _ _ _ -C05A _ _ _ 0-000S32
Magnetostrictive Linear Position Sensor – Rod Style
5
Installation and connection
5.1
Preparing for installation
Installation
For secure fastening, the BTL must be screwed to all 6
mounting holes using cylinder screws (ISO 4762,
M6×16 - A2-70) (Torque: 3.5 Nm).
Installation variants
a) Installation in non-magnetizable material
We recommend using non-magnetizable material to mount
the BTL and position magnet.
Non-magnetizable material
Position magnet
Fig. 5-1:
Installation in non-magnetizable material
b) Installation in magnetizable material
If using magnetizable material, the BTL must be protected
against magnetic interference through suitable measures
(e.g. spacer ring made of non-magnetizable material, a
suitable distance from strong external magnetic fields).
15
8
Position magnet
Spacer ring made of non-magnetizable
material
15
8
Position magnet
Spacer ring made of non-magnetizable
material
Fig. 5-2:
Installation in magnetizable material
10
english
Installation notes
Hydraulic cylinder: If installed in a hydraulic cylinder,
the position magnet should not make contact with the rod.
Minimum
bore diameter in the support piston:
Rod diameter
10.2 mm
Tab. 5-1:
Bore diameter if installed in a hydraulic cylinder
Horizontal mounting: For horizontal mounting with
measuring lengths > 500 mm, the rod must be supported
and, if necessary, screwed on at the end.
Mounting hole: The mounting surface of the BTL must
make full contact with the supporting surface. A suitable
O-ring must completely seal the bore, i.e. the countersink
for the O-ring must be produced according to Fig. 5-3.
45° ± 5°
3.2
A
15° ± 1°
0.2 A
2.4 + 0.4
Fig. 5-3:
Mounting hole for installing the BTL with O-ring
Position Magnet: Various magnets are available for the
BTL (see Accessories on page 21).
Bore diameter
At least 13 mm
25
Fitting bore
Countersink for
O-ring 15.4x2.1
Publicité
