Publicité
1
WARNINGS AND GENERAL PRECAUTIONS
• Any use other than that specified herein or in environmental conditions other than those stated in this manual is to be consid-
ered improper and is strictly forbidden!
• Important instructions: keep this manual in a safe place to enable future product maintenance and disposal procedures.
• All installation and connection operations must be performed exclusively by suitably qualified and skilled personnel with the
unit disconnected from the mains power supply.
• This manual contains important instructions and warnings for personal safety. Read carefully all parts of this manual. If in
doubt, suspend installation immediately and contact Nice Technical Assistance.
• The product packaging materials must be disposed of in full compliance with local regulations.
• Never apply modifications to any part of the device. Operations other than those specified can cause malfunctions. The manufacturer declines
all liability for damage caused by makeshift modifications to the product.
• Never place the device near the sources of heat or expose to naked flames. These actions can damage the product and cause malfuntions.
• This product isn't intended for use by people (including children) with reduced physical, sensory or mental capabilities or who lack experience
and knowledge, unless they are supervised by a person responsible for their safety.
• This product isn't a toy. Keep away from children and animals!
• The device is designed to operate in an electrical home installation. Faulty connection or use can result in a fire or electric shock.
• Even when the device is turned off, voltage can be present at its terminals. Any maintenance introducing changes to the configuration of con-
nections or the load must be always performed with a disabled fuse.
2
DEVICE DESCRIPTION
On/Off-Control2 is designed to be installed in standard wall switch boxes or anywhere else where it's necessary to control electric devices.
On/Off-Control2 enables controlling connected devices either through the Z-Wave
to it. On/Off-Control2 is equipped with active power and energy consumption metering functionality.
The device monitors load power consumption, loads energy consuption and mains voltage values. Data is transmitted through the Z-Wave
Network to the controller.
Table 1 - On/Off-Control 2 - Hardware parameters
Parameter
Power supply voltage range
Radio protocol
Radio frequency band
Max. transmitting band
Range
Supported device types
Nominal Resistive/incandescent bulbs/Halogens channel current
Nominal LED/Fluorescent (Self Ballasted Lamp) real power
Nominal electronic transformers (LED/CCFL External Ballast Lamp) channel current
Operating temperature
For installation in boxes
Dimensions (Height × Width × Depth)
Ambient humidity
Compliance with EU directives
Note
Applied load and the device can be damaged if the applied load is inconsistent with the technical specifications!
Don't connect loads greater than those recommended!
This device can be used with all devices accredited with the Z-Wave
by other manufacturers. All non-battery operated devices within the network act as repeaters to increase reliability of the network.
The device is a Security Enabled Z-Wave
the product.
2
®
Plus certificate and is compatible with such devices produced
®
®
Plus product and a Security Enabled Z-Wave
Plus network or throught a wall switch connected directly
Value
100 - 240 VAC 50/60 Hz
Z-Wave (800 series chip)
EU: 868.4 MHz, 869.85 MHz
AH: 919.8 MHz, 921.4 MHz
+6dBm
up to 100 m outdoors, up to 30 m indoors
(depending on the terrain and building structure)
• Incandescent bulbs
• LED
• Resistive
• Fluorescent lamps
• Electronic transformers
• Ferromagnetic transformer
• Halogens
2 x 5 A (10 A overall)
2 x 80 W
2 x 2 A
0 - 35ºC
Ø = 50 mm, dept ≥ 60 mm
46 × 36 × 19.9 mm
10 - 95 RH without condensation
RoHS 2011/65/EU, RED 2014/53/EU
®
Controller must be used to fully utilize
®
Publicité
