Publicité
PROBLEM
Engine Fails to start
Loss of Power; Operation erratic
Engine Overheats
Unit Vibrates
Unit does not discharge
Unit not performing
Model:
Engine Type:
Engine Power:
Rated no-load speed:
Petrol tank capacity:
Oil tank capacity:
Cutting blade part number:
Weight:
Sound pressure level LPA at the operator position:
Measured sound power level LWA:
Guaranteed sound power level LWA (2000/14/EC):
10
536672.A.0 - Masport European Chipper Owner's Manual
Troubleshooting
POSSIBLE CAUSE(S)
Fuel Tank Empty
Fuel Tank filter clogged
Spark plug wire disconnected
Faulty spark plug
Faulty spark plug
Spark plug Wire loose
Unit still running on CHOKE
Blocked Fuel Line
Fuel Tank is nearly empty
Carburettor requires setting
Dirty/Clogged Air Filter
Fuel Tank dirty
Engine Oil Low
Debris around engine
Engine Mounting Bolts loose
Chipping Blade damaged
Debris jammed into disc or blades
Uneven surface
Discharge chute clogged
Unit taking longer to process material
Technical Information
Masport Chipper MC900H 6.0HP
Honda GX200 196cm
3
4.3kW
3600/min
3100mL
610mL
536643
106kg
94 dB(A)
112.0 dB(A)
112.0 dB(A)
CORRECTIVE ACTION
Fill Fuel Tank with correct fuel
Clean Fuel Tank
Connect wire onto spark plug
Clean spark plug
Replace spark plug
Tighten spark plug connection
Move the CHOKE lever to NORMAL
Clean fuel lines
Re-fill Petrol Tank
Consult your local dealer
Clean or replace Air Filter
Clean Petrol Tank
Refill with correct grade of oil
Turn unit off and clean around engine
Tighten mounting bolts.
Check blades and replace if needed
Open exit chute and remove any debris
Move unit to a flat surface
Disconnect Spark Plug Wire then
remove and clean chute
Add dry or a different material mix
Lessen the volume going into the Chute
Replace or sharpen Chipper Blades
Check Belt for correct tension
Publicité
