Publicité
OPERATION
safe temperature. It can also be used as an energy saving function; if you want to
heat other pans, use the cooking zone that is still hot.
If all cooking zones are set to '0' and no further operation is performed, the hob will
switch off automatically after 1 minute.
Pan detection symbol
When the pan detection symbol is blinking on the display:
•
you have not placed a pan on the correct cooking zone;
•
the pan you're using is not suitable for induction cooking;
•
the pan is too small or not properly centred on the cooking zone.
The cooking zone does not work until a suitable pan is placed on the cooking zone.
▷
Connecting bridge induction cooking zones
The Bridge induction zones can be connected to each other. This creates one large zone that can
be used, for example, a grill plate or a large fish pan on the same power. The pan has to be large
enough to cover the centres of the front and rear cooking zone (> 210 mm).
Connecting bridge induction cooking zones
1. Place a pan in the middle of both bridge induction cooking zone.
2. Touch the on/off key for about 1 second until you hear an audio signal.
3. Touch a bridge induction cooking zone selection key.
On both cooking zone displays a '9' appears.
▷
4. Use a slide control to set the desired cooking power for both the connected cooking zones,
or touch one of the boost keys to activate boost for the entire bridge induction cooking
zone.
The power appears on both displays
▷
The cooking zone starts automatically at the level that has been set.
▷
Set a higher or lower power using the slide control.
▷
Disconnecting bridge induction cooking zones
1. Touch the bridge induction cooking zone selection key.
The power level is shown on both displays.
▷
The power can now be set separately for both cooking zones again.
▷
2. Set the power level of both cooking zones to '0' to switch off the cooking zones.
EN 11
Publicité
