Publicité
an Elcometer company
Any demand of greater importance against the supplier, in particular compensation for
damages, is excluded. This is also applicable to any damages that might arise during
counselling, while acquiring practice and during demonstration.
Consequently, the services rendered under guarantee do not involve an extension of the
warranty period.
The manufacturer reserves the right to make technical modifications.
17. Disposal
For complete and correct disposal of the equipment, when it has reached the
end of its useful life, it must be completely dismantled so it can be recycled,
separating the metal and plastic components.
18. Troubleshooting
ANOMALY
Air bubbles in
product outlet
The pump is
obstructed expelling
air via the exhaust
Small amount of
material reaches
gun
NOTE: The symbol (*) means that before starting the procedure it is necessary to release
pressure (see paragraph 10.1)
EN
36
CAUSE
Hydraulic cylinder (No 23) with
Threaded ends, dented or cracked.
Product suction pipe not tight
enough.
Pump suction valve assembly loose
or poorly sealed (No.26)
Incorrectly mounted or worn
distributor seal (No.5)
Damaged (No.3 or No. 9) pilot
spring
Not enough air inlet pressure
Blocked product outlet hose
Suction hose loose
or small diameter
Dirty, seized or damaged
product valves
Loose product inlet connectors or
connections
REMEDY
Rework ends with the
correct tool. (*)
Tighten loose joins.
Tighten or replace (*)
Replace faulty seals
Replace spring
Open air inlet regulator
Clean or replace
outlet hose (*)
Tighten suction hose or
place hose of appropriate
diameter for product to be
used (in accordance with
its viscosity)
Clean valves or replace (*)
Tighten connections firmly
www.sagola.com
Publicité
