Publicité
06. Warnings
Before putting the unit into operation, we recommend that you clean the equipment as this has
been subjected to functional tests and before packaging it is treated internally with a protective
coating, some of which may still remain. Apply solvent to eliminate this. Remove any residual
grease applied during assembly.
The unit is supplied depressurised (without pressure inside).
Before starting up and especially after each cleaning and/or repair procedure, you must check
that the components of the unit are perfectly tightened and that the hoses are technically suited
to the features of the equipment and the work to be carried out, in addition to being flexible and
sealed (without leaks). Faulty parts must be replaced or repaired as appropriate.
Check that the unit's safety devices work properly before using it.
The unit is easy to handle thanks to its design and the simplicity of its mechanisms. Use it
according to the operating, maintenance and safety instructions indicated in this manual and
follow the application methods indicated to obtain the required finish quality.
USE ANTISTATIC AIR HOSES. SHOULD AN ANTISTATIC AIR HOSE
NOT BE AVAILABLE, YOU MUST ATTACH THE UNIT TO A GROUND
CONNECTION IN ORDER TO ELIMINATE ANY STATIC ELECTRICITY.
You must always connect the equipment and all the elements involved in the work
process to a grounding connection to eliminate static electricity. Regularly verify (one
a week) its electrical continuity. If its resistance exceeds the recommended limits, it
must be fixed. An equipment unit without or with a faulty grounding connection may
make the installation dangerous.
The total derivative resistance must be <1 million Ohms (Ω).
Read and carefully apply all the information, instructions and safety measures given by the
manufacturer of the products to be used (products to be applied, solvents, etc.), as chemical
reactions, fire and/or explosions may occur. These may be toxic, irritant or noxious and in any
event are dangerous for the health and wellbeing of the user and the personnel around him (See
section on Health and Safety).
Ensure that the products to be applied are chemically compatible with the components of the
equipment they come into contact with (polyamide, stainless steel, steel, brass, aluminium,
polypropylene, PTFE, fluoroelastomer, polyacetal, NBR).
Do not use corrosive or abrasive products with the standard versions of the equipment.
Mix, prepare and filter the product to be applied in accordance with the
manufacturer's instructions, ensuring that no foreign particles ruin the
quality of the finish and application. Should there be any doubt on the
purity of the product, its composition, etc., please contact your supplier.
Control the viscosity of the product to be applied by means of SAGOLA
Viscosity Kit Code 56418001.
The exit speed of the product to be transferred is determined depending
on the air pressure, the product viscosity and the diameter of the hose
to be used.
Insofar as possible, cover the containers of product to be transferred to prevent its
contamination.
www.sagola.com
an Elcometer company
Ford
No.4
EN
25
Publicité
