Publicité
an Elcometer company
4.- Open the air inlet stop cock.
5.- Open the air regulator little by little until the pump begins to move.
6.- Increase the air pressure until the product is suctioned. Once the product begins to come out
of its corresponding hose, select the correct working pressure.
10. Depressurisation and stopping
10.1 Depressurisation
In order to reduce the risk or serious injury, the following procedure must be observed when
stopping the system, during assembly, cleaning or when product transfer is stopped.
1.- Operate the air inlet pressure regulator to the pump until it is in the minimum position (turning
to the left). Close the air inlet stop cock to the pump.
2.- Open the product outlet stop cock of the pump with a container near in order to collect the
product.
If you have reason to believe the cap or the hose is completely clogged, or that the pressure
has not been totally eliminated after having followed the procedure described above, loosen the
hose connector VERY GENTLY in order to reduce the pressure gradually, and finally remove it
altogether. clean the pump or the hose immediately.
Do not clean or disassemble anything while the pump or accessories are pressurised.
10.2 Stopping
SHORT STOP
When stopping for a short period of time that does not pose possible problems with catalysation
or hardening of the product inside the unit and accessories, keep the product suction tube
submerged in the product and apply the procedure of Depressurisation.
STOPPING WHEN WORK IS FINISHED
1.- Turn the pressure regulator control anticlockwise all the way (Minimum 2 - 2.5 bar / 29 - 36.2 psi).
2.- Remove the pump from the transferred product.
3.- Wait until the product stops coming out of the outlet hose.
4.- Turn the pressure regulator control anticlockwise all the way until it reads 0.
The unit is now ready to be immediately cleaned.
www.sagola.com
EN
29
Publicité
