Publicité
6. END OF COOKING
An audible signal will sound and the display will
indicate that cooking is complete.
END
Press
to continue cooking in manual mode
(untimed) or press
setting a new duration. In both cases, the cooking
parameters will be retained.
BROWNING
Some functions of the oven enable you to brown
the surface of the food by activating the grill once
cooking is complete.
PRESS v TO BROWN
When the display shows the relevant message, if
required press
to start a five-minute browning
cycle. You can stop the function at any time by
pressing
to switch the oven off.
. FAVORITES
Once cooking is complete the display will prompt you
to save the function in a number between 1 and 10
on your list of favorites.
ADD FAVORITE?
If you would like to save a function as a favorite and
store the current settings for future use, press
otherwise, to ignore the request press
Once
has been pressed, press the
the number position, then press
Please note: If the memory is full or the number chosen has
already been taken, the oven will ask you to con rm
overwriting the previous function.
To call up the functions you have saved at a later
time, press
: The display will show your list of
favorite functions.
1. CONVENTIONAL
Press
or
to select the function, confirm by
pressing
, and then press
. AUTOMATIC CLEANING PYRO
Do not touch the oven during the Pyro cycle.
Keep children and animals away from the oven
during and after (until the room has finished
airing) running the Pyro cycle.
Remove all accessories - including shelf guides -
from the oven before activating the function. If the
oven is installed below a hob, make sure that all the
6
25-Jun-2024 10:39:21 CEST | RELEASED
to extend the cooking time by
.
or
to select
to confirm.
to activate.
In some European factories the letter "W" of the part code mentioned herein will be automatically
burners or electric hotplates are switched off while
running the selfcleaning cycle. For optimum cleaning
results, remove excessive residuals inside the cavity
and clean the inner door glass before using the Pyro
function. We recommend only running the Pyro
function if the appliance contains heavy soiling or
gives off bad odours during cooking.
Press
to show "Pyro" on the display.
Pyro
Press
or
to select the desired cycle, then press
to confirm. Once a cycle has been selected, if desired,
press
or
to set end time (start delay), then press
to confirm.
Clean the door and remove all accessories as
prompted, then close the door and press
done: the oven will begin the self-cleaning cycle,
while the door locks automatically: a warning
message appears on the display, along with a
countdown indicating the status of the cycle in
progress.
Once the cycle has been completed, the door remains
locked until the temperature inside the oven has
returned to a safe level.
. MINUTEMINDER
When the oven is switched off, the display can be
used as a timer. To activate this function, make sure
that the oven is switched off and press
icon will flash on the display.
Press
or
to set the length of time you require and
then press
to activate the timer.
MINUTE-MINDER
An audible signal will sound and the display will
indicate once the minuteminder has finished
counting down the selected time.
Please note: The minuteminder does not activate any of the
cooking cycles. Press
or
timer.
Once the minuteminder has been activated, you can
also select and activate a function.
Press
to switch on the oven and then select the
function you require.
Once the function has started, the timer will continue
to count down independently without interfering
with the function itself.
Please note: During this phase, it isn't possible to see the
minuteminder (only the
continue counting down in background. To retrieve the
minuteminder screen press
currently active.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
when
or
to change the time set on the
icon will be displayed), that will
to stop the function that is
: The
Publicité
