Publicité
REPLACING THE LAMP
1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
TROUBLESHOOTING
PROBLEM
The oven is not working.
The display shows the letter "F" followed
by a number or letter.
The oven does not heat up.
The light switches off.
The door will not open.
The home power goes off.
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
•
Visiting our website
•
Using QR Code
•
Alternatively,
When contacting our After-sales Service, please state the codes provided on your product's
identi cation plate.
12
25-Jun-2024 10:39:21 CEST | RELEASED
POSSIBLE CAUSE
Power cut.
Disconnection from the mains.
Oven failure.
When "DEMO" is "On" all
commands are active and menus
available but the oven doesn't
heat up.
DEMO appears on display every 60
seconds.
"ECO" mode is "On".
Cleaning cycle in progress.
Power setting wrong.
docs.whirlpool.eu
contact our After-sales Service
In some European factories the letter "W" of the part code mentioned herein will be automatically
Please note: Only use 20-40 W/230 ~ V type G9, T300°C
halogen bulbs. The bulb used in the product is speci cally
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your ngerprints could cause damage. Do not use
the oven until the light cover has been re tted.
SOLUTION
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
Turn off the oven and restart it to see if the problem
persists.
Try to perform the "FACTORY RESET" from, selectable from
"SETTINGS".
Contact you nearest Client After-sales Service Centre and
state the number following the letter "F".
Access "DEMO" from "SETTINGS" and select "Off".
Acceed "ECO" from "SETTINGS" and select "Off".
Wait for the function to finish and for the oven to cool
down.
Verify if your domestic network has at least a rating of more
than 3 kW. If no, decrease the power to 13 Ampere. Access
"POWER" from "SETTINGS" and select "LOW".
(See phone number in the warranty booklet).
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
XXXXXXXXXX
XXXXXX XXXXXX
XXXXX XXXXXXX
Model: xxxXXXXxx
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXXXXX
XXX X X X X X XXX
XX
XXXX X X X
Publicité
