Publicité
5. When entering the automatic PIR sensor shooting mode, you can wake up the
product by turning the toggle switch to SETUP mode to check the battery
power and memory status.
6. When the battery power is low, the brightness of the IR light will be
automatically reduced when shooting at night. The shooting effect will be
slightly reduced.
7. When the lithium battery power is low, the camera will automatically switch to
the backup AA alkaline battery to continue working. When the AA alkaline
battery power is lower than one bar, the camera will stop or reduce night
shooting. When the battery is exhausted Shooting will stop. When the lithium
battery is charged by solar energy and the power recovers, the camera will
continue to work!
8. When the product works abnormally, please try to press the "R" reset button to
restart the camera, or perform a factory reset to restore relevant system
parameters.
9. When the product works abnormally, please format the micro SD card.
8. Connect to PC
Connect the product to the computer through the Type-C cable. The "Mass
Storage" prompt will be displayed on the display, indicating that the connection
to the PC is successful. At this time, the micro SD card in the machine can be read,
copied, deleted, etc.
9. Battery power
You can check the lithium battery power and the AA alkaline battery loading status
in the lower left corner of the display. The machine gives priority to using lithium
batteries for power supply. When the lithium battery power is low, the camera will
automatically switch to the backup AA alkaline battery to continue working. When
the 5 When the power of the alkaline battery drops below one level, the camera
will stop or reduce shooting at night. When the power is exhausted, it will stop
shooting. When the lithium battery is charged by solar energy and the power
recovers, the camera will continue to work!
1 2
Publicité
