Publicité
Notice:
Walk vertically in front of the PIR sensing window. If the PIR cannot sense
correctly, please walk horizontally.
The product defaults to automatically shut down after 3 minutes of no operation.
Please restart the system to continue.
7.2 Enter auto-sensing shooting mode
When the switch is pulled to the "ON" position, the product will enter the
automatic PIR sensor shooting mode. At this time, the red LED The light will flash
for 5 seconds, indicating that the machine is about to enter the automatic PIR
sensor shooting mode.
At this time, you can close the battery compartment and leave the test site. The
product will work automatically:
A. When an animal enters the main PIR sensing area, the camera will quickly start
and take pictures. After the shooting is completed, the camera Will enter sleep
state.
B. After each shooting, the camera will enter the automatic detection mode again
after 30 seconds. When an animal is detected, When there is activity in the
corresponding area, the machine will automatically turn on and take pictures
or videos, and this cycle will continue.
Notice:
1. Daytime shooting mode: The infrared light will not light up, and you can take
color photos and videos.
2. Night shooting mode: The infrared light provides the lighting required for the
product to work at night or in low light conditions. The photos and videos
taken are black and white.
3. The default interval of the product is 5 seconds, and users can set it by
themselves from 5 to 30 seconds or from 1 minute to 30 minutes.
4. Before entering the automatic PIR sensor shooting mode, please set the
working mode and related parameters in the SETUP mode.
11
Publicité
