Publicité
EN
•
Short-circuit
•
Over temperature
3.10
Accessories
3.10.1
Accessories Pentheon system
/i
Description
Battery pack
Battery charger
Mains connector
On-tool charge cable
Daisy chain power cable
3.10.2
Tool specific accessories
The table below shows the available accessories for each model with the corresponding part numbers.
/i
Description
Pulling attachments Set
Pulling chains Set
Set pulling attachments + spreading tips
3.10.3
Pulling attachments and pull chain set
Pulling attachments make it possible to use a combi tool for pulling. The pulling attachments must be
put on the blades. The pulling attachments may only be used in combination with the corresponding pull
chain set. These pulling chains consist of two parts, each with a shortening hook that only grabs the
chain. The chains are 1.5 m and 3 m long respectively.
WARNING
Hoisting is not permitted with these accessories.
The pulling accessories are intended solely for the horizontal movement of loads.
CAUTION
Check what the load is doing and make sure that it is always supported.
Make sure that the tool can move freely during pulling and always remains in a straight line
between both pulling attachments.
3.10.4
Installation of the pulling attachments
Refer to Fig. 8
•
Make sure that the blades are slightly open.
•
Push (A) and pull (B) the lock pins out untill they lock.
•
Remove the spreading tips from the blades (C).
44
model
plug type
PBPA287
PBCH1
AC-EU
PBCH2
AC-US
PBCH3
DC worldwide
PBCH4
AC-JP
PBCH5
AC-UK
PMC1
EU
PMC2
US
PMC4
JP
PMC5
UK
POTC1
worldwide
DCPC1
worldwide
150.182.078
150.582.261
150.182.365
916.400.139_002
151.000.583
151.000.629
151.000.742
151.000.632
151.000.630
151.000.631
151.000.633
151.000.743
151.000.634
151.000.635
151.000.499
151.000.503
PCT50
Publicité
