Publicité
ENGLISH
Food storage
-
When the refrigerator has been in operation for a considerable period of time, you can
adjust the internal temperature.
Once the refrigerator has cooled down completely, put the food in. It will take 2 to 3 hours
-
for the food to cool down.
-
In summer, when the temperature is high, it may take more than 4 hours for food to cool
down completely (try to open the refrigerator door as rarely as possible).
NOTE
-
If the refrigerator is installed in a wet place, be sure to check if the earth wire and the
leakage circuit breaker are working normally.
If vibration noises occur due to contact of the refrigerator with the wall or if the wall turns
-
black due to air convection around the compressor, keep the refrigerator further away
from the wall.
-
The installation of the refrigerator may cause interference in mobile phones, landline
phones, radio receivers, or televisions near the refrigerator, so in this case, keep the
refrigerator as far away from these objects as possible.
Changing the door opening direction
NOTE: if the appliance is turned upside down or on its side during this process, it should be
left in an upright position for 6 hours before plugging it in to prevent damage to the internal
components.
Below are the steps to follow to reverse the opening direction of the refrigerator door:
1. Remove the screw securing the cover from the hole in the top left side of the refrigerator.
Remove the hinge cover and hinge, located on the top right side of the refrigerator. Remove
the refrigerator-compartment door. Fig. 5
2. Remove the centre hinge on the right side of the appliance. Remove the screw hole covers
on the left side of the appliance. Remove the freezer door. Fig. 6.
3. Remove the lower hinge from the bottom right side of the appliance. Fig. 7
4. Remove the pin shaft on the right side hole of the lower hinge and insert it into the left
side hole. Fig. 8
5. Install the bottom hinge on the left side of the refrigerator. Fig. 9
6. Remove the freezer door stop from the bottom right side of the freezer and place it on the
left side of the door. Remove the refrigerator door stop from the bottom right side of the
refrigerator and place it on the bottom left side of the door. Fig. 10
7. Move the door bushing from the upper right side of the refrigerator door and remove the
hinge hole cover from the upper left side of the door. Install both parts on the opposite
side. Fig. 11
8. Fit the freezer door. Install the centre hinge on the left side of the refrigerator. Fit the screw
88
BOLERO COOLMARKET COMBI ORIGIN 231 NF E
BOLERO COOLMARKET COMBI ORIGIN 250 NF E
hole covers on the right side of the refrigerator. Fig. 12
9. Remove the refrigerator-compartment door. Place the upper hinge on the left side of the
refrigerator. Fit the screw hole covers on the top right side of the refrigerator. Fig. 13
Note: these instructions apply to models where the door opens to the right (as supplied from
the factory). If this is not the case for your refrigerator, follow these instructions by reversing
the terms "left" and "right".
4. OPERATION
Functions
When the cooling system is connected to the mains for the first time, all indicator lights on the
control panel will light up for 2 seconds.
Temperature settings
1.
You can adjust the temperature by pressing the SET icon.
2.
Each time you press it, the indicator light of the selected mode will switch off, and the
indicator light of the next mode will light up.
NOTE: if 5 seconds pass without any operation being performed, the selection of the mode
whose indicator light is lit will be confirmed. If, on the other hand, you press any icon, this
operation will not be confirmed.
Once the operation is confirmed, the temperature will be set according to the selected
3.
mode.
Fig. 3
Display
1.
SET icon
2.
Temperature settings icons
3.
Fast Cooling mode icon
The cycle of the refrigerator compartment temperature setting is as follows:
5→4→3→2→1→FAST COOLING→5
COLDEST
5
When the user needs a cooler temperature.
4
3
When it is used normally.
2
COLD
When a cooler temperature is not needed.
1
ENGLISH
BOLERO COOLMARKET COMBI ORIGIN 231 NF E
BOLERO COOLMARKET COMBI ORIGIN 250 NF E
89
Publicité
