Publicité
ENGLISH
1.PARTS AND COMPONENTS
Fig. 1
1.
Control panel
2.
Glass shelves
Temperature knob
3.
4.
Crisper drawer cover
5.
Crisper drawer
6.
Freezer drawers
Adjustable feet
7.
8.
Door shelves
Note: the graphics in this manual are schematic representations and may not exactly match
the device.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
-
Refrigerator
-
Instruction manual
3. PRODUCT INSTALLATION
Location
Ventilation
-
The location you choose to install the refrigerator should be well ventilated.
-
Do not place the refrigerator near a heat source, such as a hob or cooker, or expose it to
direct sunlight, to ensure the cooling effect and save on energy consumption.
Do not place the refrigerator in a damp place to avoid rust or loss of power.
-
-
The result of dividing the total space of the room in which the refrigerator is installed by
the amount of refrigerant load in the refrigerator must not be less than 8 g/m³.
86
BOLERO COOLMARKET COMBI ORIGIN 231 NF E
BOLERO COOLMARKET COMBI ORIGIN 250 NF E
Note: the amount of refrigerant used by the refrigerator is specified on the rating plate.
Heat dissipation space
During operation, the refrigerator releases heat into the environment. Therefore, you should
leave at least 30 mm of free space at the top, more than 100 mm on both sides, and more than
50 mm at the rear of the refrigerator.
Note: Figure 2 only illustrates the space required for the installation of the refrigerator.
Dimensions are in mm.
W
D
H
A
540
576
1700
845
540
576
1800
845
Flat surface
-
Place the refrigerator on a solid, flat surface to keep it stable, otherwise vibrations and
noises will occur.
When the refrigerator is placed on a carpet, straw mat, or polyvinyl chloride, solid support
-
plates should be placed underneath the refrigerator to avoid colour change due to heat
dissipation.
Note: the place where the refrigerator is installed must be well ventilated.
Preparation
Waiting time
Once the refrigerator is properly installed and cleaned, do not switch it on immediately. Wait at
least one hour before starting it up.
Cleaning
Check that all refrigerator accessories are securely in place and wipe the inside with a soft
cloth.
Connecting the refrigerator to the mains power supply
Connect the plug into a power socket to switch on the compressor.
-
-
After 1 hour of operation, open the refrigerator door. If you notice that the temperature
inside the refrigerator compartment is much colder than the room temperature, it means
that the refrigeration system is working normally.
ENGLISH
B
C (°)
E
F
1095
125±5
50
100
231 W
1095
125±5
50
100
250 W
BOLERO COOLMARKET COMBI ORIGIN 231 NF E
BOLERO COOLMARKET COMBI ORIGIN 250 NF E
87
Publicité
