Publicité
Installation
Installation of wired Remote Controller
Put the installation paper on the place and determine
1
the position and height of the fixing screws of the wired
remote controller.
• Refer to the printed side of the installation paper.
Plug the connecting cable into the indoor unit.
2
• The product is being shipped with the cable
connected only to the remote controller.
Fix the connecting cable with the cable rack.
Side of
remote Controller
3
Remove the installation paper before installing the
remote controller so that it can fit at the right place.
* Do not embed the remote controller into the wall.
(It may cause the breakdown of the
temperature sensor.)
* If you want to install a number of remote
controller at the same place in a vertical line,
install them at regular intervals of 20mm(1/32 inch).
(It may cause the breakdown of the temperature sensor.)
* Do not install the cable with a distance of 50m(164ft) or longer.
(This can cause communication error.)
* When installing the cable, check whether the connector between the remote controller and the
product is installed properly. The connector will not be connected when installed in opposite
sides.
❏ Supply the power after connecting wired remote controller.
When you need to change wired remote controller, switch off the main power and change it.
If the wired remote controller is changed before switching off the main power, the option function
of the indoor unit can't be used. (option function like "slo" fan speed selection)
20 Multi Air Conditioner
The position of the fixing screws
Side of
Indoor Unit
remote controller
Main
indoor unit
Red
Yellow Brown
Main frame
Fixing the
20mm(1/32 inch)
Publicité
