Brandt BT600LE Manuel D'instruction page 17

1 -
5 - PROBLEMS
Incidents may arise when using your washing machine :
If the speed lights flash and an alarm beeps, before calling Customer Service:
check whether:
the water tap is open.
5.1
A speed light other than the lights show above is flashing. If this is the case, contact your Customer Service
and tell them which light(s) is on.
Here are a few points to check :
Problems :
The washing machine will not start :
The linen is not or not sufficiently spun :
A puddle of water forms on the floor :
Strong vibrations when spin drying :
The machine does not drain :
The lid does not open :
The drum is blocked :
The drum doors open very slowly (on
machines fitted with gently opening doors) :
All the lights are off at the end of the pro-
gramme:
___
___
V maxi
rpm
check whether:
The pump filter is clogged ;
clean the filter (paragraph 4.3).
5.2
___
___
V maxi
rpm
Causes / Remedies :
- The appliance is not plugged in or there is a power cut.
- You haven't pressed the "Start/Pause" button.
- You have programmed a delayed start.
- See problems 5.1 and 5.3
- You have selected a programme without spin drying or with
limited spin drying.
- The spin safety system has detected poor distribution of the
washing in the drum : unfold the linen and programme another
spin cycle.
- Check the height of the curved drain part
First remove the plug from the socket and turn off the water
supply.
- Check that the seals
tened (Diagram 1.2) .
- Check the curved part is positioned correctly
1.3) .
- The washing machine has not been released correctly
(Diagram 1.1.3) .
- The floor is not level (paragraph 1.4) .
- You have programmed "Full drum stop".
- The drain hose is bent or squashed (Diagram 1.3) .
- See problem 5.2.
- The programme has not yet finished.
-Wait until the temperature inside the machine drops.
- If you have access, check that a small item of linen is not trap-
ped between the drum and the tank, by removing part
from the bottom of the drum (Diagram 4.2) .
- See problem 5.3.
- Your machine has not operated for a long time.
- It is located in too cold a position.
- Detergent residue (powder) is blocking the hinges.
- in all cases, everything returns to normal after the doors have
opened initially.
- All the lights automatically switch off no more than 5 minutes
after the end of the programme in order to save energy. Press
any button to restart the display.
17
check whether:
- the lid is not closed correctly.
- the drump is block
5.3
H
G
are fitted and the connectors are tigh-
___
___
V maxi
rpm
(Diagram 1.3) .
H
(Diagram
A
EN