Regular Care - Brandt BT600LE Manuel D'instruction

1 - 1 -
3 - PROGRAMMING
Opti 4
You washing machine can automatically optimise
the length of the wash cycle and the water and
energy consumption of every wash.
- Adjustment to the quantity of laundry:
Washing 1kg of laundry is not the same as washing
a full load, which is the reason why your washing
machine is equipped with sensors that detect the
quantity of laundry in the drum and automatically
calculate the right levels of water and energy requi-
red to produce a perfect wash.
- Adjustment to the hardness of the water:
The hardness of the water in your mains supply
affects the wash and rinse performances of your
appliance, which is the reason why your washing
machine automatically adapts the tumble time and
the number of rinses to produce a perfect result.
The water hardness is adjusted when you use your
washing machine for the first time (see special
insert).

4 - REGULAR CARE

4.1 - A
VOIDING BAD SMELLS
Respect the installation instructions for the drain
hose described in paragraph 1.3, leave the lid open
after the cycle has finished. Complete an empty
cycle with a washing agent at 60°C or 90°C once a
month.
4.2 - P
RODUCT DRAWER
— Release the drawer by pressing the Bumps
puyll it towards you. Remove the siphon
C
rate the drawer from the trim
— Rinse everything under the tap.
— Refit all of the parts of the drawer, then fit it back
under the lid of the machine.
EN
(continued)
(Diagram 4.1)
A ,
B , sepa-
D
.
- Adjustment to the degree of soiling:
The length and the intensity of the wash depend on
how dirty your laundry is, which is the reason why
your appliance can vary the length of the wash
cycle by up to 40% according to the selected set-
tings (see page 15).
- Adjustment to the type of textile:
Cotton shirts and cashmere pullovers do not
demand the same wash, which is the reason why
your washing machine adapts its tumble speed to
each type of textile.
For your information : The time shown on the wash-
ing machine when you select a programme corres-
ponds to the time for an average load. This time is
adjusted, once the appliance has taken its measu-
rements and then throughout the programme,
according to any unexpected events (too much
washing powder, an unbalanced load when spin-
ning, etc.).
Easy start
Your washing machine memorises your habits.
Every time a programme starts, the machine
records the options that you use most frequently,
and proposes these same options as soon as you
switch on the appliance.
4.3 - P
UMP FILTER
— Release the part
pushing a pen into the hole
right.
— Turn the drum towards the front.
— Remove the pump filter
that may be inside and rinse everything under the
tap.
— Refit both parts
A
— Push the part
4.4 - O
UTSIDE PANELS
Do not use abrasive products or scourers. Use
liquid soap. Dry with a soft cloth.
16
(Diagram 4.2)
A
at the bottom of the drum by
B and push it to the
C
, remove any objects
C A
and .
to the left until it clicks into place.