Brandt BT600LE Manuel D'instruction page 12

1 -
SAFETY
(continued)
U
SE (continued)
— This washing machine is fitted with a safety device to prevent any
spillage of water.
— At the end of the cycle, ensure the water tap is switched off and
the appliance unplugged.
ENVIRONMENT
This washing machine has been designed to res-
pect the environment.
P
ROTECTING THE ENVIRONMENT
The dose of washing product depends on how dirty
the laundry is and the hardness of the water. Do not
exceed the dose recommended by the manufactu-
rer of the washing product.
This appliance's packaging material is recyclable.
Help protect the environment by placing the packa-
ging into the municipal containers provided for this
purpose.
Your washing machine also contains many
recyclable materials, it features this logo to
remind you that used appliances must not
be mixed with other waste.
1 - INSTALLATION
1.1 - U
(Diagram 1.1.2 to 1.1.4)
NPACKING
The following instructions must be respected :
— Remove the chocks from the lid and flaps of the
drum and open and close the drum carefully.
— Lift the washing machine and remove the
B
motor chock and base
C
— Remove the strip and place the stoppers in the
— Remove the 3 hose support clips,
the stoppers in the 3 holes (very important)
(Diagram 1.1.4).
1.2 - C
ONNECTION TO THE WATER SUPPLY
(Diagram 1.2 )
Connect the feed pipe with its new washers to the
coupling on the rear of the washing machine and to
a tap with a threaded Ø 20x27 endpiece.
1.3 - D
(Diagram 1.3)
RAINING
Position the drain hose, fitted with the curved part,
H
ensuring that the instructions shown on the dia-
gram are respected and especially that the connec-
tion is not air-tight: air must pass freely between the
drain hose and the drain to avoid used water from
flowing back up the hose into the machine and bad
smells being caused.
EN
:
A
(Diagram 1.1.2) .
E
and place
The appliance must therefore be recycled in com-
pliance with the European directive 2012/19/EU on
used electrical and electronic equipment.
Contact your town hall or your retailer for the used
appliance collection points closest to your home.
E
NERGY SAVING
Only programme a prewash when it is absolutely
necessary. For linen that is not very or normally dirty,
a low temperature programme is sufficient.
1.4 - L
EVELLING THE MACHINE
The appliance must be installed on a horizontal
floor. If required, and if it is equipped with adjusta-
ble feet at the front of the appliance, stabilise your
washing machine so that it is level. If it is fitted with
retractable castors, it may be moved by pulling the
lever underneath the appliance completely to the
left.
1.5 - E
LECTRICAL CONNECTION
Ensure that the indications on the data plate of the
F
Appliance are respected.
1.6 - C
LEANING BEFORE USE
Once installed, your washing machine must be clea-
ned by programming a cotton cycle at 90°C with
nothing inside and with half a dose of washing pow-
der.
12
(Diagram 1.4)
(Diagram 1.1.1)